Publicité
Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
Device description
Illustration A
Suction hose connection
1
Battery pack mounting
2
Battery pack unlocking button
3
Power switch (On/Off)
4
Carrying handle
5
Blower connection
6
Fastening strap for suction hose storage
7
Accessory mounting
8
Container closure
9
Container
10
Upholstery nozzle
11
Crevice nozzle
12
Handle
13
Suction hose
14
*Rechargeable battery pack
15
*Charger
16
Cartridge filter
17
Filter bag
18
* optional
Installation
Opening the device
Illustration B
1. Open the container closures.
2. Carry the device head by the carrying handle.
Closing the device
Illustration C
1. Fit the device head onto the container.
2. Close the container closures.
Initial startup
Connecting accessories
Illustration D
1. Press the suction hose into the suction hose con-
nection on the device until it latches into place.
a To remove, press the latch and pull the suction
hose out.
Illustration E
2. Connect the vacuum nozzle to the handle.
Illustration F
3. Connect the crevice nozzle to the handle.
10
Inserting the battery pack
Illustration G
1. Push the battery pack into the battery pack mount-
ing from above until the battery pack latches into
place.
ATTENTION
Only use battery packs from the KÄRCHER Battery
Power (+) platform with 18 V nominal voltage.
Switch on the device
Illustration H
1. Press the I button to switch the device on.
The suction and blowing functions are switched on.
ATTENTION
Damage to the device
Always ensure that the cartridge filter is inserted, for
both wet vacuuming and dry vacuuming.
ATTENTION
Damage to the cartridge filter
When changing from wet to dry vacuuming, a wet car-
tridge filter can become damaged and unusable.
Allow the cartridge filter to dry completely before dry
vacuuming or replace it with a dry cartridge.
Replace the cartridge filter as necessary.
1. Insert the filter bag when vacuuming fine dust.
● The fill degree of the filter bag depends on the
amount of dirt vacuumed.
● The filter bag must be changed more frequently
when vacuuming fine dust, sand, etc.
● A damaged filter bag can rupture, so be sure to
change the filter bag in time.
Wet vacuum cleaning
ATTENTION
Damage due to moisture
Do not use a filter bag for wet vacuum cleaning.
Note
When the container is full, a float switch closes the suc-
tion opening and the device runs at a higher speed.
Switch off the device immediately and empty the con-
tainer.
1. To attach the upholstery nozzle or crevice nozzle to
the handle in order to vacuum up moisture or liquids,
see Chapter Connecting accessories.
Cleaning of locations that are difficult to access or
where vacuuming is not possible, e.g. leaf litter from a
gravel bed.
Illustration I
1. Push the suction hose into the blower connection
until the suction hose latches into place.
Illustration H
1. Press the 0 button to switch the device off.
Illustration J
2. Push the battery pack unlocking button forwards
and pull the battery pack upwards out of the battery
pack mounting.
3. Charge the battery pack if necessary, see the oper-
ating instructions of the battery pack and the charg-
er.
English
Operation
Dry vacuuming
Blowing function
Ending operation
Publicité
