Publicité
Adjustment of coupling point for control handle B
The coupling point for control handle B (12) can be adjusted so that the handle does not
have to be pushed down so far to activate the cylinder. To adjust the coupling point, the
spring (green arrow 1) must be pressed down using the nuts (orange arrow 2). Start with
the lower nut and then the middle nut. Finish by turning the top nut (blue arrow 3) down in
level.
For vehicle towing
When vehicle towing, pull the log cradle and lifting bar must be put in transport position.
A: Pull the spring pin and push the log cradle in the direction of the arrow and fix the spring
pin so it is locked in position.
B: Pull the spring pin and push the lifting bracket in the direction of the arrow and fix the
spring pin.
34
Publicité
