Publicité
Step 7:
Add engine oil (0.6L SAE30)
1. Make sure the log splitter is on a level surface.
2. Remove oil fill cap to add oil.
3. Refer to the separate owner's engine manual for the amount needed of SAE10W-30
engine oil; replace oil fill cap/dipstick.
4. Check engine oil level before use and add if needed.
NOTE: During the break-in period check the engine oil level often.
Step 8
Add gasoline to the engine
1. Use only clean, fresh, regular unleaded E5 fuel (Octane 98/100).
2. DO NOT mix oil with fuel.
3. Remove the fuel cap and slowly add fuel to the tank. DO NOT overfill allow
approximately ¼ inch of space for fuel expansion.
4. Screw on the fuel cap and wipe away any spilled fuel.
Step 9
Add hydraulic oil
1. The log splitter needs to be on a flat, level surface before adding the hydraulic oil.
2. Remove the oil cap from the hydraulic reservoir.
3. Add 11 liters of hydraulic oil AW32, AW46 & universal hydraulic oil are all acceptable
types of fluid. Automatic transmission fluid should be used when operating in
temperatures below 32 degrees
(all units are tested and have excess oil in the ram).
4. Check the hydraulic oil level.
5. Start engine and use the control lever to extend and retract wedge several times to
remove air from the lines.
6. With the wedge retracted, check hydraulic oil level again and fill if necessary.
Important warnings before start
The log splitter is a tool which, if used wrongly, can cause serious accidents. It is
important that you read and understand the user manual before using the tool, especially
the safety warnings marked with the symbol:
The log splitter is only intended for splitting logs of wood, if the size corresponds to
the recommended indicates: Length 25-61 cm. Diameter 20-40 cm.
DO NOT at any time carry passengers, sit or stand on the log splitter.
Check the hydraulic oil level and visually inspect all hoses and attachments for
problems.
Inspect the engine and make sure the engine oil level is correct.
therefore
28
Publicité
