Publicité
smartRail
Operation on touch panel
Changing the factory setting of
1.5. Reset and update of smartRail
the functions for a locomotive or
If smartRail does not function faultlessly, please reset the integrated Z21 digital command centre to the
switching additional F-keys requires
factory settings:
an external control device:
This can be a Smartphone or a tab-
1. Hold the " " button down for 5 seconds. The LED begins to blink blue.
let PC (see page 34) or a classic
2. After that, the factory settings of smartRail have been reset. If the digital system still does not react
multiMAUS (see page 40).
faultlessly, please ask your specialised dealer for help.
When your Smartphone or your tablet PC is connected to the internet, you can look for software updates
for your apps and for the Z21 fi rmware integrated in smartRail at the App Store and at Google Play in the
area "Updates".
1.6. Fault conditions
• Short circuit: Function keys and arrow keys remain dark white. The " " key blinks red.
• Sensor error due to contact interruption or due to locomotives that are too short and positioned too
closely to the sensor or locomotives that cannot be controlled: All keys except the on / off switch turn
off. The " " key blinks red.
• Limited touch operation: If the " " key glows pale red, the scanning procedure did not fi nd a locomo-
tive.
32
2. External control units: Smartphone, tablet PC,
The touch panel is the easiest, fastest and most comfortable way to control your locomotives on
smartRail. However, there are good reasons to use a Smartphone, a tablet PC or a
external control device – for instance:
• To use more than only the four basic functions (F1 to F4) of your locomotives.
• To program your locomotives – maybe to re-defi ne function assignment, driving stages, start-up and
braking behaviour or top speed.
• To control your locomotives remotely.
The following pages will tell you what you need to know to connect and operate external end devices to
smartRail.
External control
MAUS
multi
MAUS as
multi
33
Publicité
