Publicité
Problem
The temperature in the re-
frigerator is too high.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as
shown in the figure.
4. Replace the bulb with one of the same
power and specifically designed for house-
hold appliances (the maximum power is
shown on the light bulb cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light
comes on.
Technical data
Dimension
Height
Width
Depth
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
28
Possible cause
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
3. If necessary, replace the defective door
ZRG716CW
850 mm
550 mm
612 mm
230 V
50 Hz
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a
location where the ambient temperature corre-
Solution
Store less products at the same
time.
Make sure that there is cold air circu-
lation in the appliance.
stallation".
gaskets. Contact the Service Center.
ZRA720CW
1050 mm
550 mm
612 mm
230 V
50 Hz
ZRA726CW
1250 mm
550 mm
612 mm
230 V
50 Hz
www.zanussi.com
Publicité
