Important - Columbus AKS 80 Mode D'emploi

the prongs onto the lifting hooks (all three) marked as A/B/C in Fig. 1 and using a forklift or bridge crane (with a suitable
capacity for the machine), lift it off of the pallet and very slowly place it on the ground.
___________________________________________________________________________________________
THE MACHINE CAN ONLY BE LIFTED WHEN ALL THREE STRAPS ARE HOOKED ONTO THE RESPECTIVE
LIFTING HOOKS.
___________________________________________________________________________________________
4) Retrieve the relative ramps for the pallet and put them in position, screwing them on with the supplied screws, as shown in
Fig. 2; remove the pieces of wood that surround the wheels and disengage the parking brake Fig. 3, pressing it to release the
brake lever. It is now possible to push the machine onto the slide (this must be carried out when no one is stationed in front
of the machine and on a spacious flat surface)
At the end of the unpacking operation, take off and store the hooks (eye bolts), and install the right and left side brooms, as
shown in paragraph "side broom replacement" in chapter 13.
IMPORTANT: All waste material from the unpacking operations must be disposed of by the user, in accordance with
MAKE SURE THAT THE GUARDS ARE PERFECTLY INTACT AND SECURELY INSTALLED; IN CASE OF
FAULTS OR MISSING PARTS DO NOT PROCEED WITH COMMISSIONING AND PROMPTLY ASK FOR SPARE
PARTS FROM YOUR DEALER OR THE PARENT COMPANY.
IMPORTANT: Do NOT use and do NOT leave the machine parked with temperatures over + 40° C (+ 104° F).
ALLOWED OPERATING CONDITIONS
AKS 80|BM 108 series sweepers are designed to clean processing residues, dust, debris in general, all flat, hard surfaces that
are not overly rough such as: cement, tarmac, stoneware, ceramic, wood, sheet metal, marble, rubber mats or made with plastic
materials in general, coarse or smooth, synthetic or flat fibre carpeting, in closed or outdoor settings.
FORBIDDEN OPERATING CONDITIONS
AKS 80|BM 108 series sweepers with a standard control unit cannot be used on gradients greater than 20%.
They cannot be used in settings where there are explosive or flammable materials.
They cannot be used on dirt, gravel or very rough roads.
They cannot be used to collect oils, poisons and chemical materials in general, (if the machine is required for use in
chemical companies it will require a specific clearance issued by the dealer or the parent company).
They cannot be used on urban and non-urban roads, they cannot transit on any public roads.
They cannot be used in facilities with poor lighting, as they are not equipped with head lights.
They cannot be towed in any way, not in private facilities, nor in public roads or locations.
They cannot be used to remove snow, or used to wash or de-grease wet or very damp surfaces in general.
They cannot operate where there are wires or wire-shaped elements, as the nature of the material to be collected is
incompatible with the rotating movement of the brooms.
They cannot be used in any way as a stand for objects or to be used as a raised platform for objects or people.
Never allow people near the range of action of the machine.
Do not make any changes of any kind unless authorised by the manufacturer.
the specific standards for disposal currently in force.
CHAP. 4 – ALLOWED ENVIRONMENTAL CONDITIONS
Minimum operating temperature:
Maximum operating temperature:
CHAP. 5 – INTENDED AND FORBIDDEN USE
- 20° C
+ 38° C
18
Vacuum sweeper
AKS 80|BM 108
( -4° F)
(+100.4° F)