Publicité
Type E (Diamond Surface Grinding
Wheel Guard) with Concrete Dust
Extraction Attachment for Surface
Grinding
A Type B (27) grinding wheel
guard may not be used for
all tool operations. Do not discard guard when
not in use . Always reinstall wheel guard when
converting back to grinding operations .
Dust Extraction Attachment
is not a guard, do not use
with bonded abrasive wheels. Dust extraction
attachment may not protect operator in the
event of a wheel burst .
To Install Concrete Dust Extraction
Attachment
(Fig. 1, Fig. 2, Fig. 12)
1 . Unplug tool from power source .
2 . Position the Concrete Dust Extraction At-
tachment on the Guard Mounting Flange
with the Dust Port pointing away from the
tool body .
3 . Rotate the Concrete Dust Extraction Attach-
ment clockwise 90º until it clicks in place .
4 . Adjust the Concrete Dust Extraction Attach-
ment by depressing the Guard Release/Ad-
justment Lever 9 and rotate the Concrete
Dust Extraction Attachment to the desired
position .
5 . Allow the Guard Release/Adjustment Lever 9
to click in place .
6 . Place the Backing Flange 6 on the Spindle 5 .
7 . Place the diamond cup wheel onto the Spin-
dle 5, and align it with the Backing Flange 6 .
8 . Thread on the Lock Nut 14 and tighten the
Lock Nut 14 using the lock nut wrench, while
holding the Spindle Lock 8 .
When using spin on wheels, follow steps 1 - 5,
then thread the wheel directly onto the Spindle
5 without using the supplied flanges .
TO REMOVE: Reverse procedure .
24
160992A98J GWS14-50PBD 202405.indd 24
Assembly
Fig. 12
(9)
(8)
(5)
Wheel
Guard
Concrete
Extraction
Attachment
Spindle
Neck
Dust
5/16/24 9:13 AM
Publicité
