Publicité
Kickback Control:
The electronics in the power tool detects situ-
ations where the wheel or accessory may be at
risk to bind . The electronics prevents further
rotation of the drive spindle by switching the
power tool off (it does not prevent kickback) . To
resume operation, turn on/off switch to the off
position, then restart tool .
Constant Response Circuitry:
Helps maintain near constant RPMs between
no-load and load conditions .
Soft Start:
Helps reduce stress on the motor that occurs
from a high torque start . Helps bring accessory
smoothly up to speed .
Automatic Restart Protection:
Helps prevent accidental startups after power
has been interrupted, e .g . the tool was un-
plugged with the switch locked in the on posi-
tion . To resume operation, turn on/off switch to
the off position, then restart the tool .
The brake action of this
grinder is not intended as a
safety feature. Do not set the tool down before
the tool comes to a complete stop. Using the
appropriate guard when operating the grinder is
your best protection against unintentional con-
tact with a spinning accessory . Unintended con-
tact with a rotating accessory can cause prop-
erty damage and/or personal injury .
Your grinder is equipped with an automatic elec-
tric brake which is designed to help stop the
accessory from spinning after you release the
trigger switch .
160992A98J GWS14-50PBD 202405.indd 15
Functional Descriptions
page heading
Overload Protection:
Helps protect tool from excessive heat that may
damage motor . If tool stops or slows during op-
eration, allow motor to cool for 30 seconds by
running no-load . If the overload protection stops
the tool repeatedly, excessive force is causing
the tool to overload . Stop excessive force and
readjust work piece to reduce force applied .
Drop Control:
The power tool is equipped with sensors that
detect impact to the grinder . The tool will turn
off if it is dropped on most hard surfaces from
height greater than one foot, or hit with force ap-
proximately equivalent to more than a one foot
drop . After any impact or activation of the shut
off feature, always inspect the grinder and the
battery for signs of damage and do not use the
tool or the battery if any damage is suspected .
Brake Operation
Braking starts once the power is turned off .
Stopping time will vary depending on, factors
such as, type and size of accessory used, and
frequency of switch actuations . Factors such as
contamination or failure of the motor's compo-
nents can cause the brake not to activate . If the
tool operates but the brake does not engage to
help stop the accessory, DO NOT continue using
the grinder, and have it serviced by a Bosch Fac-
tory Service Center or Bosch authorized service
facility .
15
5/16/24 9:13 AM
Publicité
