Publicité
CORDLESS OPERATION
When the battery is fully charged, the green FULL BATTERY light will
blink. When the battery charge is low, the green FULL BATTERY light
will turn off and the red CHARGE BATTERY light will blink (Figure G).
Once the battery has fully run down (after approximately 180 minutes
of use), the red CHARGE BATTERY light will turn off, indicating that the
battery should be recharged or the nail grinder should be used with
the adapter cord (Figure G).
USE WITH ADAPTER CORD
If the nail grinder powers off in the middle of a job, the adapter cord
can be attached to continue use in corded operation. When the unit is
running with the adapter cord attached, the green FULL BATTERY light
will remain on and the red CHARGE BATTERY light will blink (Figure G).
USING THE GRINDER ATTACHMENTS
Your Andis nail grinder comes with a conical grinding stone, a grinding
wheel and a multi-function protective cap (Figure G). It is
recommended to use only Andis attachments made specifically for the
CNG-1 nail grinder.
The multi-function protective cap has three ports, suitable for use on
small or large size pets (Figure H). The multi-function protective cap
should only be used with the grinding wheel.
• Use Port "A" for small sized pets.
• Use Port "B" for large sized pets.
• Use Port "C" for quick nail grinding. Use your thumb and index finger
to hold your pet's paw, and touch the grinder slightly to start
grinding the nail. Do not keep the grinding stone against the nail
for longer than three seconds at a time. (Figure H).
To remove multi-function protective cover: Twist counterclockwise
to unlock and pull straight up (Figure I).
To remove grinding wheel: Grip the grinding wheel and pull straight
up.
To insert a new grinding wheel: Insert new grinding wheel into slot
and push down firmly.
IMPORTANT: Before each use, check that the grinding stone or wheel
is secure. If loose during operation, attachment may be ejected from
nail grinder and cause injury.
9
Publicité
