Publicité
CHARGING NAIL GRINDER
The battery charger is intended for use with Andis CNG-1 nail grinder.
Remove the nail grinder and charger from the carton. Plug the
charger into a 230V AC outlet.
The nail grinder must be OFF before plugging the charger into the
outlet. Plug the adapter cord plug directly into the bottom of the nail
grinder (Figure G). The nail grinder has a lithium-ion battery that
cannot be damaged by overcharging.
Nail Grinder in Use
Full Charge
Low Charge
Turbo Speed
Nail Grinder Charging
When Charging
Fully Charged
NAIL GRINDER INDICATOR LIGHTS
See the chart for charging status and corresponding indicator lights.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an
appliance you know is working).
2. Check to make sure adapter cord plug is plugged firmly into bottom
of nail grinder. If failure to charge still exists, return nail grinder to
Andis or an Andis authorized service station for examination and
repair or replacement.
8
NAIL GRINDER INDICATOR LIGHT STATUS
Indicator Light Status
FULL BATTERY light blinks
CHARGE BATTERY light blinks
TURBO light on (RED)
Indicator Light Status
CHARGE BATTERY light on
FULL BATTERY light blinks
CHARGE BATTERY light off
FULL BATTERY light on
Publicité
