Publicité
Display (user interface)
Preselecting the Torque
You can select the required torque in 9 stages using the but-
tons for torque preselection 1 and 2 ((23)/(21)). The power
Screwdriving process status indic-
ator
Green
Red
Orange
Torque preselection in 9 stages
The diagram displayed describes the individual stages with
the associated torque and the corresponding machine screw
(see figure F).
The torque values in the diagram have been measured under
standardised measuring conditions and are for reference
only. The actual torque may be influenced by various factors.
To increase the torque, press the button for torque
preselection 1 (+) (23). To decrease the torque, press the
button for torque preselection 2 (-) (21). The corresponding
Bosch Power Tools
Description
The battery status indicator (17) lights up
red.
The temperature alarm indicator (16)
lights up red.
tool is stopped automatically when the set torque is
reached.
A tightening status indicator (14) and an audible alarm sig-
nal will indicate the status of the screwdriving process (see
table and figure D below).
Audible alarm signal
–
Audio signal (1 second)
Audio signal (1 second)
torque preselection setting is shown in digits on the torque
preselection display (22).
Selecting the working mode
The power tool has 2 working modes.
English | 11
Meaning
The battery in the power tool is empty and
needs to be replaced or recharged.
– The power tool has overheated. Allow
the power tool to cool down before you
carry on working.
– The power tool or rechargeable battery
is charged wirelessly. Allow the power
tool or rechargeable battery to charge
fully before you carry on working.
Meaning
The screwdriving process is proceeding
without any problems.
The torque is the same as the selected
torque preselection setting.
A fault has occurred during the screwdriv-
ing process.
Possible causes:
– The on/off switch was released too
soon
– The battery in the power tool is nearly
empty (see "User Interface
(see figure B)", page 9)
– The power tool detects a sudden load
change
– The overload protection on the power
tool is active
A fault has occurred during the screwdriv-
ing process.
Possible causes:
– The power tool is running at no load
– The power tool does not detect an im-
pact
1 609 92A 9DD | (27.06.2024)
Publicité
