Care & Cleaning; Periodic Maintenance - Toto EcoPower STD TELS10 Série Manuel D'installation Et D'utilisation

Turn on the water supply at the stop valves
and inspect all the connections for any
leaks (see Ill. 1).
Place hand under the sensor to activate.
For 10 sec model: water will stop after 10
seconds while your hand is under the sensor.
Water will stop when you remove your h and.
For 20 sec model: water will stop after 20
seconds.
IMPORTANT! Do not scratch the sensor when
cleaning the spout (see Ill. 2).
Never use polishing powder, detergent that includes
coarse particles, thinners, benzene, acids, alkaline
detergents, or nylon scrub brushes, as they
can damage the surface of the spout.
To safely clean the surface, wipe it using a dampened
soft cloth with diluted dishwashing detergent
and dry it with another soft cloth. If this does not
adequately clean the surface, wipe the area with a
neutral detergent and wet cloth.
Check your faucet at least once a month for the following potential problems and to do the
following maintenance procedures:
Inspect for Leakage
Check all water connections for signs of leakage.
Tighten the Spout
If the spout is loose, tighten the hexagonal nut underneath the spout for deck-mounted
models.
To tighten the Helix Wall-Mounted Spout:
1. Unscrew the escutcheon, tighten the three screws securing the mounting bracket to
the wall.
2. Reinstall escutcheon.
To tighten the Gooseneck Wall-Mounted Spout
1. Turn off the water supply at the stop valves and disconnect the spout connecting hose
from the controller.
2. Remove the spout from the mounting bracket by removing the set screw on the bottom
of the spout base.
3. Tighten the set screw on the back of the spout, then reinstall the spout on the mounting
bracket.
4. As required, ensure the set screw on the mounting bracket and mounting nuts behind the
sink/wall (refer to "Install the Spout" section) are tight.
INSTALLATION PROCEDURE
Testing after installation
CARE & CLEANING

PERIODIC MAINTENANCE

7
Ill. 1
Close
Open
Ill. 2
Stop Valve
Sensor
Area
Outlet