Toto EcoPower STD TELS10 Série Manuel D'installation Et D'utilisation page 9

Cleaning the Inlet Strainer and Nozzle
• When the inlet strainer is clogged, the flow rate will decrease. Decreased flow rate can
lead to insufficient power generation, which will deplete the backup battery prematurely.
• To clean the strainer (see Ill. 1):
1. Turn the water off at the stop valves.
2. Remove controller cover and then remove
quick fastener.
3. Remove contorller.
4. Remove strainer and clean it with a brush.
5. Re-install the clean strainer.
IMPORTANT!
Be sure to install fow regulator in the correct
orientation as shown. Otherwise, product does
not function properly.
6. Re-install the controller into the adaper until
fully seated, and secure it with the quick
fastener.
7. Re-install cover, securing it with the screws.
8. Open angle stop and check all
connections.
• To clean the nozzle (see Ill. 2):
1. Remove the nozzle from the spout
with the suppplied tool.
2. Clean the nozzle with a soft brush
to remove any dirt from the screen.
3. Re-install the nozzle in the spout.
Power supply
Sensor Detection Range
Water Supply Pressure
Water Supply Connection
Inlet Temperature range
Ambient Temperature
Humidity
Flow Rate*
Duration Time of Water
Discharge*
* Refer to specificatin sheet or consult with a TOTO Rep. for model numbers, flow rate and
water discharge duration of each model.
Ill. 2
Open
SPECIFICATIONS
Hydropower Generation (self-powering power supply)
5-1/8"~ 7-7/8" (130~200mm)
Sensor is self-adjusting.
Minimum required water pressure: 15 psi (100 kPa) (Flowing)
Maximum water pressure: 80 psi (551 kPa)
G1/2 compatible with ½ NPSM
39 ~ 110°F (4 ~ 43.3°C)
32~104°F (0~40°C)
0.09 gpc (0.36 Lpc) *
0.18 gpc (0.67 Lpc) *
0.19 gpc (0.72 Lpc) *
8
Ill. 1
Flow
Regulator
Strainer
Spout
Nozzle
Spout
Nozzle
Close
Key
Max. 90% RH
10 seconds*
20 seconds*
Quick
Fastener
Brush