Publicité
• Before doweling check concrete floor with quality C20/25 if the concrete floor
goes to the top edge of the floor. In this case the dowels have to be chosen
according to the picture on page 18. If the ground is covered with floor tiles,
the dowels have to be chosen according to the pictures.
9.3 Initiation
Before the initiation the first security check needs to be performed. Use form
"First security check".
If the lift is installed by a competent person, he will perform this security check. If
the operator installs the lift by himself, he has to instruct a competent person to
perform the security check.
The competent person confirms the faultless function of the lift in the installation
record and the form for the first security check and allows the operation of the lift.
Please send the filled installation record to the manufacturer after
initiation.
9.4 Changing the installation place
If the place of installation shall be changed, the new place has to be prepared
according to the regulations of the first installation. The changing should be
performed in the following process:
• Loosen the dowels at the base plate and operation panel.
• Lift up automotive lift 20 inch without vehicle.
• Underlay scantlings underneath the centre axis of the shears.
• Lower automotive lift until centre axis bears on scantling and loose bearing and
fixed bearing lift up from floor. Fix lift to prevent it from oscillating or tilting.
• Brace loose bearing and fixed bearing with rail.
• Loosen pneumatic and hydraulic pipes and electric cables.
• Transport the automotive-lift to its new location.
• Install the lift in accordance with chapter 9 "Installation and Initiation".
Use new dowels, the old ones are not usable anymore.
A security check must be performed before re-initiation by a competent
person. Use form "Regular security check".
UNI LIFT 6500 - 8000
Operating instruction and documentation
- 56 -
UNI-LIFT 6500 - 8000
Version 4.2
Publicité
