Publicité
EN
TARE Key
The weight of the item on the weighing pan is subtracted as the weight of
a container (tare weight).
5. Setup
1.
Take the base unit and the pole out of the
packing box while being careful not to pull the
load cell cable.
2. Remove the weighing pan from the base.
3.
Assembling the pole
Temporarily remove the screws attached to the
bottom of the weighing base, and then fasten
the pole and base with the removed screws,
taking care that the load cell cable is not pinched.
Bundle and insert the excess load cell cable into
the pole from the display side.
4. Put the weighing pan on the base unit.
If using the scale in a location where static electricity is
easily generated or where it may get wet, secure the
grounding wire with the earth (ground) terminal (M4
screw).
6.
Maintenance
・Refer to the FG-CWP/FG-ACWP Series Instruction Manual on our website
for sensitivity adjustment.
・Periodically check the accuracy of weighing. Adjust the scale, if it is moved to another location or the
environment has changed.
6.1. Repair
Do not disassemble / assemble the scale without an authorized service engineer. Doing so may
cause an electric shock or damage to the scale, etc. In this case, repair is not covered under
warranty. Contact your local A&D dealer if your scale needs service or repair.
Display Unit
2.
Weighing
Base Unit
Earth
(Ground)
Terminal
8
Pole
Pan
1.
Load Cell Cable
3.
Rear of Display Unit
https://www.aandd.jp
Publicité
