Publicité
CAUTION! RISK OF INJURY! Broken lamp glass must
be replaced before any further use is made of the product.
Only intended for installations out of normal reach.
This product does not contain any parts that can be serviced by the
user. The LEDs and built-in LED control gear cannot be replaced by
end user.
If the LEDs fail at the end of their lives, they must be repaired by
qualified electrician or the entire product must be replaced.
The spotlight is only suited for use with the built-in LED control gear.
The product continues to draw a small amount of power even if the
lamp is off as long as product is connected to supply mains. To switch
the product off completely, remove the fuse or switch off the circuit
breaker at the fuse box.
Before installation
Important: The electrical connection must be established by a qualified
electrician or a person trained to perform electrical installations.
This person must be familiar with the properties of the product and the
connection regulations.
Before installation ensure that the circuit, to which the product will be
connected, is not energised. To do so, remove the fuse or switch off the
circuit breaker in the fuse box (0 position).
Use a voltage tester to verify the de-energised status.
The included mounting material is suitable for ordinary solid concrete
or masonry construction. Check which mounting material is suitable
for your chosen mounting surface. If necessary, seek expert advice.
Before use
Note: Remove all packaging materials from the product.
GB/IE/NI
9
Publicité
