Publicité
Connect the lead of the cable with the terminal block
tion box
. Pay attention to the markings on the terminal block
6
(L for live, N for neutral and
Close the connection box
Align the spotlight
to slacken the fastening screws
fastening screws
Reinsert the fuse or switch the circuit breaker back on. Your product is
now ready to use.
Start-up
Adjusting the motion detector
Depending on the pre-adjustments of the motion detector
will switch itself on for a certain period of time as soon as the motion
1
detector
detects movement. These pre-adjustments are made using the
9
three controllers on the underside of the motion detector
Setting the lighting duration
Turn the rotary control TIME
the illumination. The lighting duration can be adjusted within a time
window of approx. 10 seconds to 4 minutes.
Adjusting the sensitivity of the sensor
Turn the rotary control SENS
of the sensor.
Note: The motion detector
outdoor temperatures are low, it is more sensitive to body heat than
for the earth wire) (Fig. C).
.
6
into the desired direction. For this, you may need
1
. After finish the alignment, tighten the
8
again, to ensure a secure hold.
8
clockwise to increase the duration of
11
clockwise to increase the sensitivity
10
responds to heat radiation. When
9
in the connec-
13
13
, the spotlight
9
(Fig. B).
9
GB/IE/NI
11
Publicité
