Publicité
Installation
Make sure you will not be drilling into electrical, gas or water lines inside
the wall. Use a power drill to drill the holes into the brick wall. Always ob-
serve all safety instructions for the power drill in the manual for the power
drill. Death or injury due to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Make sure that the spotlight
move the spotlight
Make sure the motion detector
detector
9
angle of about 180° (depending on the mounting height – a height of
2.50 m is ideal) (Fig. D).
Make sure the motion detector
lighting. This can influence its functioning.
During mounting, proceed as described below:
Unscrew the locking screws
detach the mounting stirrup
Hold the mounting stirrup
spirit level) against the wall and mark the fastening holes.
Now drill the fastening holes (Ø 6 mm) and push the wall plugs into
the drill holes (Fig. A).
Secure the mounting stirrup
Now use the screwdriver (cross type) to attach the spotlight
mounting stirrup
tooth lock washers
Open the connection box
connection box
Insert the connection cable (not included), type H05RN-F 3G 1.0 mm
through the cable gland
for the connection cable line should not exceed 2.5 m. Fix the connec-
tion cable with the cable clamp
the cable gland
10 GB/IE/NI
vertically.
1
has a maximum coverage range of 12 m, with a coverage
4
4
4
by using the previously removed locking screws
4
, and metal nuts
2
6
with a cross type screwdriver.
6
and into the connection box
7
.
7
illuminates the desired area. You can
1
covers the desired area. The motion
9
is not illuminated at night by street
9
by using a screwdriver (cross type) to
5
from the spotlight
so that it is horizontal (possibly with a
onto the wall using the screws provided.
(Fig A).
3
after you have released the lid of the
first and then by turning the nut of
14
.
1
to the
1
5
. The length
6
,
,
2
Publicité
