Publicité
Securely attach the feet to the heater using the self-tapping screws.
Return the heater to the upright position.
Set-up and Operation
Make sure the heater is turned off and that the thermostat dial is set to
maximum (clockwise, as far as it will go). Now plug into an earthed, correctly
functioning 220-240V / 50Hz socket. Only connect the heater to an earthed
socket!
In order to switch on the heater, set one or both mode selector dials to 650W.
c.q. 850W. The light(s) on the related switch(es) turn(s) on and the heater
starts to function. For slow heating, a small rise in temperature or a small
space, choose setting 650W. For quick heating, a bigger temperature rise or a
larger space, choose setting 850W. 650W and 850W together give full power:
1500W.
When the space has reached the desired temperature, turn the thermostat dial
anticlockwise slowly until you hear a click. In this position, the thermostat will
maintain the current temperature by turning the heater on and off for a top-up,
if necessary. If so desired, you can now switch to a lower power level. For
higher temperatures, turn the thermostat dial clockwise, for lower temperatures
anticlockwise.
To switch off, click the mode selector dial to off. The heater switches off, the
pilot light will turn off. Unplug.
Safety features
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. In case of overheating, switch off
the heater and unplug. Give the heater time to cool down, remove the source of the
overheating and use as normal. If the problem persists or if you have not been able
to trace the source of the overheating, turn the heater off immediately and unplug.
Contact a servicing point to have the heater repaired.
Cleaning and maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do
not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
31
Publicité
