Publicité
• Check the product for damage and wear be-
fore each use. The product may only be used
in good order and condition!
• Warning. The toy creates flashes of light that
may trigger epilepsy in sensitive persons.
Warnings on batteries!
• Remove the batteries if they are empty or if
the product is not going to be used for an
extended period.
• Do not use different battery types or brands,
new and used batteries in combination, or
batteries with different capacities, as they leak
and can thus cause damage.
• Observe the polarity (+/-) when inserting
batteries.
• Change all batteries at the same time and
dispose of the old batteries properly.
• Warning! Batteries may not be charged or
reactivated in any way. They may not be dis-
mantled, thrown into fire, or short-circuited.
• Always keep batteries out of the reach of
children.
• Do not use rechargeable batteries!
• The cleaning and user-maintenance may not
be carried out by children without supervision.
• Clean the batteries and the device contacts as
necessary and before inserting the batteries.
• Do not expose the batteries to extreme
conditions (e.g. radiators or direct sunlight).
Otherwise there is an increased risk of leaks.
• Warning. This product contains a coin battery
(button cell with lithium). If swallowed, a coin
battery can cause internal chemical burn
injuries.
• Warning. Dispose of used batteries imme-
diately. Keep new and used batteries out
of the reach of children. Seek medical help
immediately if you suspect that batteries have
been swallowed or ingested.
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it properly and
immediately. Wear gloves to handle the
battery.
• If you come into contact with battery acid then
wash the affected area with soap and water.
If battery acid gets in your eye rinse it out with
water and seek medical help immediately!
• Do not short-circuit the terminals.
Inserting/replacing batteries
(fig. B/fig. D/fig. E)
WARNING! Comply with the following
instructions in order to prevent mechani-
cal and electrical damage.
For inserting and replacing the batteries (17)/(18)
proceed as shown in fig. B/fig. D/fig. E.
Note: You will need a suitable screwdriver (not
contained in delivery).
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
The batteries must be located entirely inside the
battery compartment.
Assembly
To assemble the product, follow the individual
steps as shown in Figs. F–H.
Assembly variants
Assembly variants can be found in the enclosed
overview.
Note: assembly variants with multiple, con-
secutive curved parts can potentially derail the
vehicles!
Clean the tracks with a damp cloth before using
them for the first time!
Use
Safari vehicle (Fig. C)
1. Slide the switch (7a) to 'ON' to turn the
product on.
2. Press the front button (7b) to drive forwards.
3. Press the middle button (7c) to stop the safari
vehicle.
4. Press the back button (7d) to drive backwards.
Warning! The safari vehicle is not intended to
drive backwards on bridges or inclines.
5. Slide the switch (7a) to 'OFF' to turn the
product off.
GB/IE
13
Publicité
