Maico ECA 100 ipro Notice De Montage Et Mode D'emploi page 24

7 Installation and commissioning
Economy program
• Power level 1 during operation and overrun
time.
• J4 open, J5 bridged
Adjustable
Switch-controlled
start delay
operating time
Power program
• Power level 2 during operation and overrun
time.
• J4 bridged, J5 open
Adjustable
Switch-controlled
start delay
operating time
7.5 Final mounting
DANGER due to short circuit/fire if mois-
ture penetrates into the terminal compart-
ment. A flat installation position is prescribed
for the electronics cover, not curved! This
must lie tightly against the housing all
around.
24
Adjustable
overrun time
Adjustable
overrun time
I, II, III Locking tabs
1. Push the electronics cover onto the 3 locking
tabs at the housing recesses I, II and III, one
after the other, until it clicks into place. Press
the electronics cover firmly into the housing at
both positions indicated by the word PRESS.
Ensure tightness to the housing.
2. For device versions F, KF, H, KH, B and KB,
insert the supplied sensor in the correct posi-
tion (→ arrows X), into the connector socket.
H and KH: Do not touch/push on the mem-
brane on the flat side of the sensor wall, other-
wise it will be damaged.