Publicité
Status
Color
Tool
Green
registration
Cancelling/
Red
erasing
tool
registration
Others
Red
Off
Troubleshooting for wireless activation function
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
The wireless activation lamp does
not light/blink.
Wireless activation lamp
On
Blinking
(slow: 2 times/sec.)
(fast: 5 times/sec.)
-
Probable cause (malfunction)
The wireless unit is not installed into the
cleaner and/or the tool.
The wireless unit is improperly installed
into the cleaner and/or the tool.
The terminal of the wireless unit and/or
the slot is dirty.
The wireless activation button on the
tool have not been pushed.
The stand-by switch on the cleaner is
not set to " I (ON)".
No power supply
Duration
(approximate)
20 seconds
Ready for the tool registration. Searching the tool to be
registered.
2 seconds
The tool registration has been finished. The wireless
activation lamp will start blinking in blue.
20 seconds
Ready for the cancellation of the tool registration.
Searching the tool to be cancelled.
When the
Ready to erase all tool registrations.
wireless acti-
vation button is
pressed down.
2 seconds
The tool registration has been cancelled/erased. The
wireless activation lamp will start blinking in blue.
3 seconds
The power is supplied to the wireless unit and the wireless
activation function is starting up.
-
The stand-by switch is not set to " I (ON)".
Remedy
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot of the cleaner and/
or the tool.
Push the wireless activation button on the tool
briefly. Make sure that the wireless activation lamp
is blinking in blue.
Set the stand-by switch on the cleaner to " I (ON)".
Supply the power to the tool and the cleaner.
23 ENGLISH
Description
Publicité
