Publicité
Connecting and Installing the System Control Box
The left and right sides of the System Control Box are pre-installed with its Covers in the
factory. The main system control board is on the right.
The safety wires are used to prevent the Right Cover from falling when accessing the
System Control Box. Please ensure that the safety wires are never removed.
Use caution as the System Control Box panel is separated into two pieces with wires
attached.
Before installing the System Control Box, the Power and Network Cables of the
Cabinets at the lowest row must be routed through the holes provided in the System
Control Box from behind (see Appendix B for example system wiring diagram).
Left Cover
1. Carefully place the System Control Box on stable furniture that can safely support the
System Control Box.
2. The rubber hole plugs installed on the rear of the System Control Box are used to
protect the Cables from rubbing against any pointed edges. Use a knife to cut the
hole to size along the cross.
Connector Plate
Safety wires
Right Cover
Main system control board
7
Steel plate
Publicité
