Publicité
4. Repeat Step 2~3 for the remaining Upper Wall Mount Bracket(s).
5. Install the Lower Wall Mount Brackets in the same manner as the Upper Wall Mount
Brackets.
NOTE:
You can also install the Upper Wall Mount Brackets, hang the screen, and
then install the Lower Wall Mount Brackets for a more precise fit.
Installing the Cabinets
Before installing the Cabinets on the Wall Mount Brackets, it is recommended to refer
to the wiring diagram provided in Appendix B first to decide how you want to route the
Cables for the power and network connections to the Cabinets.
Additionally, the rubber hole plugs installed on the Cabinets are used to protect the
Power and Network Cables from rubbing against any pointed edges. After installing all
Cabinets, use a knife to cut the rubber hole plugs to size along the cross according to the
thickness of the Cables.
1.
Locate the Cabinet to install the left Upper System Control Box Mount Bracket (see
Appendix B to identify the Cabinet).
NOTE:
• One Cabinet is divided into separate sections. You can identify these Cabinet
sections by the labels on each section or the package.
• The arrow marks on each Cabinet section should be pointing up.
2. Place each section of the Cabinet on stable furniture that can safely support them.
3. Attach the Cabinet sections together with the provided screws (M8 x 20 mm).
4. Install the left Upper System Control Box Mount Bracket to the side of the assembled
Cabinet with the provided screws (M8 x 20 mm).
5. Repeat Step 1~4 for the right Upper System Control Mount Bracket.
6. Repeat Step 2~3 for the first Cabinet. Start from the center, and move to the right
and left sides of the Wall Mount Brackets (see Appendix B to identify Cabinet
sections and installation sequence)
7. Carefully lift the assembled Cabinet onto the center of the Upper Wall Mount
Brackets.
5
Publicité
