Publicité
8. Install the provided screw (M8 x 16 mm) on the Lower System Control Box Mount
Bracket. Thread the provided M8 nut onto the screw and fully tighten the nut.
9. Repeat Step 7 for the other Lower System Control Box Mount Bracket.
10. Remove the pre-installed Power and Network Cables of the Cabinets from the
System Control Box.
NOTE:
It is recommended to take photos of the completed wiring in the left and
main system control boards before removing the Cables.
11. After removing the pre-installed Power and Network Cables of the Cabinets, connect
one end of the longer Network Cable to the network port that was disconnected
from the System Control Box in Step 10.
NOTE:
• Refer to Appendix B for example system wiring diagrams, including wire
colors and connection points.
• Ensure to match the corresponding letters on the Cables to the network
ports of the System Control Box (A to A, B to B, C to C, and so on).
12. Carefully thread the Network Cables through the hole provided in the System Control
Box to the rear (see Appendix B for the position of the cable holes). Avoid sharp
bends in the Cables.
NOTE:
The rubber hole plugs must always be placed in the holes.
13. After threading all Network Cables of the Cabinets, connect the longer Power Cables
to the AC unit(s) of the System Control Box.
DO NOT connect the System Control Box Power Cable(s) at this time.
• Connect the neutral wires (usually white/blue) to the "N1" and "N2" terminals.
• Connect the hot wires (usually black/brown) to the "L1" and "L2" terminals.
• Connect the ground wires (usually in green) to the ground terminals.
The meaning of wiring color may vary by country.
Use the provided wrench to tighten the neutral, hot, and ground conductors
in the terminals properly.
11
Publicité
