Publicité
14. Thread the Power Cables of the Cabinets through the hole provided in the System
Control Box to the rear (see Appendix C for the position of the cable holes). Avoid
sharp bends in the Cables.
NOTE:
• The rubber hole plugs must always be placed in the holes.
• Before threading the Cables through, ensure that the output and input
terminals are properly grounded, and that the wire colors/labels are
matched with the marked terminals and each wire is screwed firmly to its
corresponding terminal.
15. Connect the AC unit(s) of the System Control Box to the main system control board.
16. Connect the LED Display's left speaker to the Audio Out port.
NOTE:
Ensure that the right speaker is properly connected to the other Audio Out
port.
17. Connect the IR Extension Cable to the main system control board. Then, route it
through the hole of the System Control Box to the rear.
NOTE:
Refer to Appendix C for the position of the cable holes.
18. After connecting all Cables and wires, hold the top edge of the Right Cover toward
the System Control Box to replace it. Once the Right Cover is replaced, it will be held
in place magnetically.
NOTE:
Ensure the Power Button cable is connected before securing the Right
Cover.
19. Replace the Left Cover by aligning it properly with the System Control Box; then the
Left Cover should attach magnetically.
20. Align the Lower System Control Box Mount Brackets with the Upper Mount Brackets
to attach.
12
Publicité
