Publicité
Separate the filters and rinse all filters under running water using a soft brush.
Clean the filters once a week.
Replace the flat filter and replace the filter assembly by turning them clockwise
until they lock into position.
CAUTION: Never operate the dishwasher without the filters.
Cleaning the spray arms
It is necessary to clean the spray arms regularly, otherwise hard water chemicals
will clog the spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
Frost precaution
Please take frost protection measures on the dishwasher in winter. Every time
after washing cycles, please operate as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the
water valve.
3. Drain the water from the inlet pipe and water valve (Use a pan to gather the
water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up
water in the sump.
128
SDW4910WH2-SDW4910SL2-4LANG-IB.indd 128
SDW4910WH2-SDW4910SL2-4LANG-IB.indd 128
To remove the upper spray arm, screw off the nut
clockwise to take out the washer on the spray arm
and remove the
arm.
To remove the lower spray arm, pull it out.
Wash the arms in soapy and warm water and use
a soft
brush to clean the jets.
Replace them after rinsing thoroughly.
FR
NL
EN
PT
1/3/2024 10:58 AM
1/3/2024 10:58 AM
Publicité
