Publicité
1. Loosen the clamp 1.
2. Remove the oil collecting pipe 2 together with the
clamp 1.
3. Drain all the waste liquid in the oil collecting pipe 2.
4. Reinstall the oil collecting pipe 2 and fasten the clamp
1.
NOTE: Be true that reinstall the collecting pipe.
NOTE: When air is very humid, properly increase the
inspection frequency.
SPARK PLUG
Spark plug inspection
Measure the spark plug gap with a thickness gauge. The
standard spark plug gap is 0.8–0.9mm. If the measured
spark plug gap is out of standard range, adjust or replace
it with a new one.
Whenever removing carbon deposits, be sure to observe
the operational color of the spark plug's porcelain tip. This
color tells you whether or not the standard spark plug is
suitable for your type usage. A normal operating spark
plug should be very light brown in color. If the spark plug is
very white or glazed in appearance, it has been operating
Haojue UF115 99011H5A001H000 V02 ES+EN+FR 2019-4-11
much too hot. This spark plug should be replaced with a
colder plug.
Spark plug replacement guide
An improper spark plug may have an incorrect fit or
heat range for your engine. This may cause severe
engine damage.
Use one spark plug listed below or equivalent.
Consult your Haojue dealer or a qualified mechanic
if you are not sure which spark plug is correct for
your type of usage.
NGK
CPR5EA-
9
0.8–0.9mm
CPR6EA-
9
CPR7EA-
9
NOTE: This motorcycle uses a resistor-type spark plug
to avoid jamming electronic parts.
plug selection may cause electronic interference with
your motorcycle's ignition system, resulting in motorcycle
performance problems. Use only the recommended spark
plug.
33
Haojue UF115 99011H5A001H000 V02 ES+EN+FR 2019-4-11
BCAUTION
BCAUTION
Remarks
If the standard spark plug is apt to get wet,
replace with this plug.
Standard.
If the standard spark plug is apt to overheat,
replace with this plug.
(93)
EN
Improper spark
(93)
Publicité
