Publicité
GEAR SHIFT LEVER
(A)Forward stepping (B)Backward stepping
The operation of the gearshift is as shown above. After
a speed is chosen, the gear shift lever will automatically
return to its original position for next gear shifting.
When stopping, change the gear directly from the fourth
to neutral; when driving, you do not do that; and instead,
if necessary, change the gear gradually from the higher to
lower and finally neutral.
Reduce speed before down-shifting.
down the pedal rod at the rear part of the gear rod
while slightly increasing the rotation speed of the engine
before the gear rod spontaneously restores to the original
position.
Increase speed before up-shifting. And then pedal down
the pedal rod at the fore part of the gear rod while slightly
decreasing the rotation speed of the engine before the
gear rod spontaneously restores to the original position.
When change the gear according to the steps above,
unnecessary wear on the drive train components and the
rear tire can be prevented.
Haojue UF115 99011H5A001H000 V02 ES+EN+FR 2019-4-11
(A)
(B)
(C)
(C)Only when stopping
And then pedal
15
Haojue UF115 99011H5A001H000 V02 ES+EN+FR 2019-4-11
BCAUTION
Before shifting, close throttle grip completely.
REAR ABSORBER SPRING ADJUSTMENT
The rear absorber spring pre-load is adjustable to
compensate for rider, load, driving style and road
conditions.
The spring pre-load is adjustable to five
positions. Twist the spring tension ring to the desired
position with the spring adjuster.
the softest spring tension and position 5 provides the
stiffest. This motorcycle is delivered from the factory with
its adjuster set on position 2.
BWARNING
The rear absorber springs on the left and right
sides must be placed in the same position.
Improper adjustment will affect ride stability.
(75)
Position 1 provides
EN
(75)
Publicité
