Télécharger Imprimer la page

GASLAND GH Serie Mode D'emploi page 12

Publicité

Gas Connection For Gas Cooktop
The gas cooktop should be connected to the gas-supply by a registered
installer. During installation it is essential to fit an approved gas tap to
isolate the supply from the cooktop for the convenience of any
subsequent removal or servicing. Connect the cooktop to the gas mains
or liquid gas, it must be carried out according to the prescribed
regulation in force, and only after it is ascertained that it is adaptable to
the type of gas to be used. If not, follow the instructions indicated in the
paragraph headed "Adapting To Different Types Of Gas ". In the case of
connection to liquid gas by tank, use pressure regulators that conform to
the regulation in force.
Important: For safety, for the correct regulation of gas use and long life of
the cooktop, ensure that the gas pressure conforms to the indications
given in table 1 "Burners And Nozzle Specifications".
Connection to non- exible tube(copper or steel)
Connection to the gas source must be done in such a way as to not
create any stress points at any part of the gas cooktop.
The cooktop is fitted with an adjustable "L" shape connector and a
gasket to the gas supply.
The connector should be dismounted and the gasket must be replaced.
The feeding connector of the gas to the cooktop is threaded 1/2 in gas
tank.
Connection to exible steel tube
The gas feed connector to the cooktop is threaded, 1/2 in connector for
round gas pipe. Only use pipes and sealing gaskets that conform to the
standards currently in force. The maximum length of the flexible pipes
must not exceed 78.7 in. Once the connection has been made, ensure
that the flexible metal tube does not touch any moving parts and not be
crushed.
Check the seal
Once the cooktop was installed, make sure all the connections are
properly sealed, use a soapy soluion to test, never use flame.
10

Publicité

loading