Bosch 500 Serie Manuel D'utilisation page 9

5.3 Basic Operation
Filter pull-out
Pulling out the filter drawer
Note: The appliance starts with the functions that were set
when the drawer was closed.
Hold the filter drawer by the middle and pull it out.
▶
a The control panel is accessible and the appliance is
ready for operation.
Pushing the filter drawer in
Note: The ventilation is switched off when the drawer is
closed, the light stays on.
Hold the filter drawer by the middle and push it in.
▶
Turn on the fan
Note: Always adjust the fan strength to meet current
conditions. If there is a large build-up of steam or fumes,
select a high fan setting.
Press ⁠ .
1.
a The current ventilator settings are indicated by a bar on
the display panel.
Press or to change the ventilator settings.
2.
Turn off the fan
Press repeatedly until the ventilator switches off.
▶
Switching on intensive mode
For especially strong odor or vapor, use the intensive
mode.
Press while the appliance is at ventilation setting 3.
▶
is displayed.
a
a After 5 minutes, the electronics automatically turn the
appliance down to ventilation setting 2.
Turn the fan up
Switch on lighting
Fan run-on
Switching off intensive mode
Press the until the required setting is reached.
▶
Switching on lighting
The lighting can be switched on and off independently of
the ventilation.
Press ⁠ .
▶
Saturation notification
The saturation of the metal grease filter or of the active
carbon filter is indicated on the display panel.
¡ Grease filter: Ventilator setting 3 and intensive setting
blink in alternation.
¡ Odor filter: Ventilator setting 3 and intensive setting
blink simultaneously.
If you have not yet done so, the metal mesh grease filters
should be cleaned or the activated carbon filter changed
now.
For instructions on how to clean the metal grease filters,
refer to the section
→ "Cleaning and maintenance", Page 9 .
Resetting the saturation displays
Press and hold ⁠ .
▶
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display
must be switched over accordingly:
Requirement: The extractor hood must be connected and
switched off.
Press and simultaneously until ventilator settings 1
1.
and 2 light up briefly on the display panel..
To switch the electronic control display back to exhaust
2.
air mode repeatedly press the button combination.
a Display ventilator setting 1 lights up briefly
6 Cleaning and maintenance Cleaning and maintenance
To keep your appliance working efficiently for a long time,
Cleaning and maintenance
it is important to clean and maintain it carefully.
6.1 Cleaning agents
You can obtain suitable cleaning products from Customer
Service or the online shop.
NOTICE:
Unsuitable cleaning agents may damage the surfaces of
the appliance.
Do not use strong or abrasive cleaning agents.
▶
Do not use cleaning agents with a high alcohol content.
▶
Do not use hard scouring pads or cleaning sponges.
▶
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
Cleaning and maintenance en-us
9