Publicité
BMS (BMS Reset)
After the car battery is replaced, the car battery control unit needs
to be reset. This will clear fault information (such as low battery level)
so that the control unit can match the relevant information of the
newly replaced battery.
Airbag (Airbag Reset)
This function allows you to reset the airbag data to turn off the
airbag light, so that the airbag control module can run normally.
It needs to be performed in the following cases:
• When the airbag deploys;
• When the diagnostic tool reads "Crash data stored";
• When the airbag light is on;
• When relevant DTCs cannot be cleared.
4.3.2 Steps:
To perform a service reset:
1. Tap Maintenance from the home screen of the ArtiDiag900 Lite
app. A function menu will display.
2. Select a desired function that you want to perform.
3. Identify the vehicle via VIN or Make (for more on identification
operations, refer to Identifying the Vehicle in 4.2.1). Then the screen
30
Figure 4-10
Publicité
