Publicité
3.2 Plug the ArtiDiag900 Lite VCI into the Vehicle's DLC
Take the ArtiDiag900 Lite VCI out from the back slot of the
ArtiDiag900 Lite tablet and plug it into the vehicle's DLC. The
vehicle's DLC port is usually located under the dashboard.
If you encounter a problem in locating the DLC, please go to Library
> DLC Location for more details, or refer to the vehicle's service
manual.
Note: Make sure the ignition is always OFF before plugging in the
ArtiDiag900 Lite VCI.
3.3 Turn the Ignition to the "ON" Position (see Figure 3-8)
If your vehicle is equipped with a keyless start system and the
ignition switch is an "Engine Start Stop" button (see Figure 3-9), press
the "Engine Start Stop" button until the car is in "ON" mode. Do not
apply the brake while pressing the "Engine Start Stop" button, or you
will start the car instead of putting it in the "ON" position.
The method of ignition varies by vehicle model. Refer to the vehicle's
service manual for details.
12
Car OBD-II Interface
Figure 3-7
Publicité
