Publicité
TFA_No. 35.1174_Anleitung
26.09.2024
Funk-Wetterstation
• Low batteries should be changed as soon as possible to prevent damage caused by leaking. Make sure the
polarities are correct. Never use a combination of old and new batteries together, nor batteries of different
types. Remove the batteries if the device will not be used for an extended period of time. Avoid contact with
skin, eyes and mucous membranes when handling leaking batteries. In case of contact, immediately rinse
the affected areas with water and consult a doctor.
CAUTION
• Unauthorised repairs, alterations or changes to the devices are prohibited.
• Do not expose the devices to extreme temperatures, vibrations or shocks.
• Clean the devices with a soft damp cloth. Do not use solvents or scouring agents.
• The transmitter is splashproof, but not watertight.
3. Elements
Base station (Receiver)
A: Display (Fig. 1):
A 1:
Weather forecast with weather symbols and trend indicator
A 2:
Channel 1/2/3 and circle symbol for alternating channel
A 3:
Outdoor temperature
A 5:
Reception symbol for the outdoor transmitter
A 7:
Indoor temperature and humidity
A 9:
Comfort level
A 11: DCF reception symbol
A 13: Brightness level
A 15: Date
B: Buttons (Fig. 2):
B 1:
LIGHT sensor button
22
10:54 Uhr
Seite 12
A 4:
Battery symbol for the outdoor transmitter
A 6:
Daily HI/LO values outdoor temperature
A 8:
MAX/MIN values
A 10: Battery symbol for the base station
A 12: Alarm symbol
A 14: Radio-controlled clock with seconds
A 16: Day of the week
B 2:
AL button
Funk-Wetterstation
B 3:
CH button
B 5:
–/MIN button
C: Housing (Fig. 3):
C 1:
Wall mounting hole
C 3:
Battery compartment
Transmitter (Fig. 4):
D: Display:
D 1:
Channel 1/2/3
D 3:
Battery symbol for the transmitter
E: Housing:
E 1:
Battery compartment
E 3:
Indentations for the holder for wall mounting
F: Buttons in the battery compartment
F 1:
TX button
4. Getting started
4.1 Insert the batteries in the transmitter
• Place the base station and the transmitter on a table at a distance of about 1.5 meters from each other.
Avoid being close to possible sources of interference such as electronic devices and radio equipment.
• Remove the protective film from the base station display.
• Open the battery compartment of the transmitter and insert two new AA 1.5 V batteries, polarity as illus-
trated. All LCD segments will be displayed for a short moment.
• The transmitter display shows the temperature. The switch is set to channel 1.
• Close the battery compartment.
B 4:
MAX/+ button
B 6:
SET button
C 2:
Stand (fold out)
C 4:
Power supply connection
D 2:
Transmission signal
D 4:
Outdoor temperature
E 2:
Holder for table standing
F 2:
1 2 3 switch for channel selection
23
Publicité
