Publicité
ENGLISH
Getting Started
Cautions on installation
Note:
For heat dispersal, do not install this unit in a confined space such
as a bookcase or similar enclosure.
About the remote control unit
In addition to controlling the AVR-1907, the attached remote control
unit (RC-1046) can also be used to control the following products:
q DENON component products
w Component products other than DENON:
• Set using the preset memory function (
Note
Inserting the batteries
q Remove the remote control
unit's rear cover.
Wall
e Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the "<" and ">" marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• Remove the batteries from the remote if it will not be in use for
long periods.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
Operating range of the remote control unit
• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of approximately
23 feet/7 meters, at a horizontal angle of up to 30° with respect to
the sensor.
page 58).
w Set two R6P/AA batteries in
the battery compartment in
the indicated direction.
NOTE:
• It may be difficult to operate the remote control unit if the remote
3
ENGLISH
30°
30°
Approx. 23 feet/7 m
sensor is exposed to direct sunlight or strong artificial light.
Getting Started
Publicité
