Publicité
ENGLISH
Easy Setup Procedure
e Perform the Auto Setup procedure
1
SYSTEM SETUP
Press
.
2
D D H H
Press
to select "Auto Setup", then press
3
D D H H
Press
to select "Auto Setup", then press
The message "Connect Microphone" is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
1
2
3
• "System Setup" menu is not displayed when using headphones.
r Assigning power amplifiers
The surround back output can be assigned to the "Front" or "ZONE2"
output.
D D H H
Press
to select "Power Amp Assign", then press
G G
to set.
Surround Back:
Assign to use as surround back speaker.
ZONE2:
Assign to use as "ZONE2" speakers.
ENTER
.
Front A, Front B:
Assign to use the "Front A" or "Front B" speakers with bi-amp
connections.
ENTER
.
When assigned to "Front" or "ZONE2", skip the surround back
channel measurement.
During the auto setup procedure, test tones are not output to
"ZONE2".
t Switching the front speaker
D D H H
Press
to select "Front Sp", then press
the speaker.
Front A
Front B
y Starting Auto Setup
D D H H
Press
to select "Start", then press
• Start the measurements.
F F
Measurement of each channel is performed as follows:
1
FL
FR
C
SW
1: The subwoofer speaker is measured twice.
2: Not displayed when "ZONE2" and "Front" are set at
"Setting the Power Amplifier Assignment" (
After each channel is measured, "Calculating" appears.
The display switches to the Auto Setup check screen
automatically.
ENGLISH
NOTE:
• Do not change the speaker connections or subwoofer volume
after making the measurements.
• Do not turn off the power while the data is being stored.
Cautions during measurements:
• Loud test tones are output during the measurements. Be careful
for example when small children are nearby.
• Proper measurements may not be possible if there are obstacles
between the speaker and the setup microphone.
• During the measurements, do not stand between or near the
speakers and setup microphone.
• To avoid influencing the measurements, turn off the power of air-
conditioners or any other equipment producing sound in the
F F G G
to select
room. Perform the measurements with the room as quiet as
possible.
• Measurement is cancelled when VOLUME is operated while the
Front A+B
Auto Setup is performed.
¢ About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to two times. During this time,
F F
.
"Retry1" or "Retry2" is displayed on the screen.
2
SL
SR
SBL
SBR
page 53).
11
Easy Setup Procedure
Publicité
