Publicité
ENGLISH
Connecting Other Sources
Connecting a CD recorder or MD recorder
• If you wish to perform analog dubbing from a digital source, such as a CD or MD recorder to an analog
recorder such as a tape deck, you will need to connect the analog inputs and outputs as shown below,
in addition to the digital audio connections.
• If you choose to use the coaxial or optical connection, it needs to be assigned. For more information
about Digital Input Assignment (
• The source selected for MAIN ZONE is output from the digital output terminal (OPT-2).
The source selected in the REC SELECT mode is not associated with the output from the digital output
terminal (OPT-2).
NOTE:
• Do not connect the output of the component connected to the OPTICAL 2 OUT terminal on the AVR-
1907's rear panel to any terminal other than the OPTICAL 2 IN terminal.
page 47).
A
L
R
D
D
A
L
R
Connecting the antenna terminals
An F-type FM antenna cable plug can be connected directly.
Direction of broadcasting station
FM antenna
CD recorder /
MD recorder
AUDIO OUT
75 Ω/ohms Coaxial cable
L
L
R
R
OPTICAL
OUT
FM indoor antenna (Supplied)
OPTICAL
IN
AUDIO IN
L
L
R
R
¢ AM loop antenna assembly
1
Remove the vinyl tie
and take out the
connection line.
4
a. With the antenna on
top any stable
surface.
b. With the antenna
attached to a wall.
17
ENGLISH
AM loop antenna
Ground
Connect to the AM
antenna terminals.
2
3
Bend in the reverse
direction.
Mount
Installation hole Mount on wall, etc.
Connecting Other Sources
(Supplied)
AM outdoor antenna
Connection of AM antennas
1. Push the lever.
2. Insert the conductor.
3. Return the lever.
Publicité
