Easy Setup Procedure
Speaker connections
Connect the speaker terminals with the speakers
making sure that like polarities are matched (
with
,
with
).
<
>
>
NOTE:
When making connections, take care that
none of the individual conductors of the
speaker cable come in contact with adjacent
terminals,
with
other
speaker
cable
conductors, or with the rear panel and
screws.
NEVER touch the speaker terminals when
the power is on. Doing so could result in
electric shocks.
Connecting the speaker cables
1. Loosen by turning
counterclockwise.
Either tightly twist or terminate the core
wires.
2. Insert the cable.
3. Tighten by turning clockwise.
Connecting banana plugs
Turn clockwise to tighten, then
insert the banana plug.
¢ Speaker impedance
<
Speaker
Impedance
Front A, B
6 ~ 16 Ω/ohms
Front A+B
12 ~ 16 Ω/ohms
Center
Surround
6 ~ 16 Ω/ohms
Surround back / ZONE2
Note on speaker impedance
When using speakers with an impedance
below the designated value (for example 4
Ω/ohms), playing for long periods of time with
the volume high could cause the temperature
to rise, activating the protection circuit.
When the protection circuit is activated, the
output to the speakers is cut off and the power
indicator blinks. If this happens, unplug the
power cord, wait for the set to cool off and
improve ventilation around the unit. Also check
the wiring of the input cables and the speaker
cables. After doing this, plug the power cord
back in and turn the unit's power back on.
If the protection circuit is activated again even
though there are no problems with the wiring or
the ventilation around the unit, switch off the
power and contact a DENON service center.
¢ Connections
• With the AVR-1907, up to ten speakers can be connected for surround playback.
• When making connections, also refer to the operating instructions of the other components.
Center
speaker
Subwoofer
>
<
( L )
( R )
<
>
>
<
Front speakers
(B)
8
ENGLISH
Easy Setup Procedure
Surround
speakers
Connection terminal for
subwoofer with built-in
amplifier.
( L )
( R )
IN
>
< >
( L )
( R )
( L )
( R )
<
>
>
<
>
< >
Front speakers
Surround back
(A)
speakers
When using only one surround back
speaker, connect it to the left channel.
ENGLISH
<
<