Care and cleaning instructions
• Never spray liquids onto the telephone since any liquid penetrating the telephone can lead
to malfunctions or destruction of the device.
• Any substances such as alcohol, chemicals, solvents or scouring agents should also be
avoided since these may damage the surface.
• Clean the telephone with a soft cloth moistened with water.
Documentation on Internet
This and other documentation can be found on the Internet
www.unify.com
Technical notes, current information about firmware updates, frequently asked ques-
tions and lots more can be found on the web
Package Content
OpenScape Desk Phone CP200/CP205
Stand
Handset
Handset cable
Installation and Quick Reference Guide
Notes about Place of Use
• Operation of a SIP telephone is only permitted with indoor LAN cabling. The device
shall be connected to the IP infrastructure using a shielded LAN cable: Cat-5 for
100 Mb/s or Cat-6 for 1000 Mb/s. The LAN cabling of the building shall ensure that
the shield of this cable is grounded.
• The telephone should be operated in a controlled environment with an ambient
temperature between 5 °C and 40 °C (41 °F and 104 °F).
• Do not install the telephone in a room where large quantities of dust accumulate;
this can considerably reduce the service life of the telephone.
• Do not expose the telephone to direct sunlight or any other source of heat, as this
is liable to damage the electronic equipment and the plastic casing.
• Do not operate the telephone in damp environments such as bathrooms.
Connect the Handset to the Telephone
See also overview on page 2.
1. Insert the plug on the long end of the handset cable
on the base of the telephone and press the cable into the groove
E
provided.
2. Insert the plug on the short end of the handset cable
jack on the handset
Support.
.
at:http://
at:http://wiki.unify.com
into the jack
into the
9