Publicité
9.6 Work light
■
Press and hold the HOLD button to switch the work light ON / OFF.
9.7 Relative mode
Relative mode can be used to take differential readings between two test points or
for tracking changes in measurements from a defined reference point (e.g., line
losses).
1. Select a function using the rotary switch: V
2. Take a measurement and note the displayed value.
3. Press the REL button to activate relative mode.
"REL" will appear on the display to indicate relative mode is active.
à
4. Take another measurement.
The display will show the difference between the new reading and the initial
à
reading.
5. Press the REL button to exit relative mode.
6. Switch the power OFF after use.
10 Measurement
IMPORTANT! Always observe the information contained in the section:
Safety instructions
DANGER
Risk of electric shock!
Never exceed the maximum permitted input values for this
product.
Use caution when circuits may contain voltages above 30 V/AC
rms (42.4 V peak), 60 V/DC.
[} 41].
, V
, 4A , 40A .
49
Publicité
