Publicité
USER'S MANUAL. TV EXPLORER HD
ASI OUTPUT SOURCE
It allows you to select the output signal between two options: DEMODULATORS
and AUXILIAR. The DEMODULATORS option uses the TS coming from the
internal demodulator, which is active at that time. The AUXILIARY option uses any
video file.
TS INPUT SOURCE
It allows selecting the TS to use in the decoder. The INTERNAL option uses the
TS coming from the internal demodulator of the instrument. The EXTERNAL
option uses the TS connected through the TS-ASI input by the user.
You can also access the TS-ASI option from the MEASUREMENT mode. Press
the key for measurement configuration
the bottom of the menu until the option Enable ASI INTERFACE.
Select the option by pressing the rotary and turn it to switch from OFF to ON.
Press the rotary to accept the change. Now there is a new option:
ASI OUTPUT SOURCE option as explained above, allows selecting the output
between two options: DEMODULATORS and AUXILIAR. The option DEMODULATORS
uses the TS that comes from the internal demodulator which is active at that time. The
AUXILIARY option uses any video file.
5.22
TV Operating Mode
When pressing the
HD
accedes to the TV mode, and tries to demodules on the monitor the currently video
signal on tune.
02/2010
Figure 58.-
[17] to access the SETUP menu and go to
[10] key from any mode of operation the TV EXPLORER
Page 77
Publicité
