4�4�2 Setting The Start Addresses; 4�4�3 Assigning The Channel Functions; Operation - IMG STAGELINE LC-324DMX Mode D'emploi

4.4.2 Setting the start addresses
Set the start addresses of all spotlights (FIXTURE)
or spotlight groups according to the table below
☞
( manual of the spotlights) .
Number of
channels
FIXTURE 1 FIXTURE 2 FIXTURE 3 FIXTURE 4
3 1
4 1
5 1
6 1
7 1
8 1
4.4.3 Assigning the channel functions
Different types of spotlights vary in the extent
and the sequence of functions . Therefore, the
controller can be set to the channel functions
of the type of spotlight used .
1) While the controller is still switched off, set
switch 1 of the switch group (12) to the
upper position .
Note: The positions of the other three
switches are irrelevant in this case .
2) Use the POWER switch (7) to switch on the
controller . The controller is now in the assign
mode (patch mode) .
3) To delete any previous assignments, press the
button BLACK OUT (11) . The LED of the but-
ton will briefly flash to confirm the process .
4) For all functions of the spotlight supported by
the controller, enter the channel number and
the channel function one after another . Only
the function indicated below the buttons is
relevant in this case:
Use the buttons 1 – 4 (1) and 5 – 8 (3) to select
the channel number . Then use the buttons
COLOUR (2) to define the corresponding
channel function: RED, GREEN, STROBE,
WHITE, BLUE, MASTER .
Example: To assign the function "brightness of red
LEDs" to channel 2, first press the button "2" and
then the button "RED" .
After each assignment, the LEDs will flash to
confirm the process .
Note: For any channel of a spotlight to which no
function has been assigned, the controller will al-
ways send the value zero during operation .
Start addresses
4 7 10
5 9 13
6 11 16
7 13 19
8 15 22
9 17 25
5) For normal operation, set switch 1 to the
lower position again .
Note: Do not change the settings of the
other switches made in chapter 4 .4 .1 .
6) Switch off the controller with the POWER
switch (7) .

5 Operation

1) Use the POWER switch (7) to switch on the
controller .
2) Use the buttons FIXTURE (1) to select /dese-
lect the spotlights to be adjusted . When a
spotlight has been selected, the LED of the
corresponding button will light up .
3) Use the buttons COLOUR (2) to select a col-
our or press the button FADER (9) and use
the controls (4) for an individual adjustment .
Note: The availability of individual control functions
depends on the type of spotlight used and on the
assignment to the channel functions (
ter 4 .4 .3) .
4) Select and adjust further spotlights as de-
sired . If a spotlight is deselected, it will retain
its current setting .
5) If desired, call up automatic colour change
☞
programs ( chapter 5 .1) or use special
effects:
STROBE (chapter 5 .2)
FLASH (chapter 5 .4)
BLACK OUT (chapter 5 .5)
6) After use, switch off the controller with the
POWER switch . The power supply unit will
still consume some power when the con-
troller has been switched off . To prevent
unnecessary power consumption, always
disconnect the power supply unit from the
mains if the controller is not used for a longer
period of time .
☞ chap-
13