Publicité
2. Locate the vehicle's 16-pin
Data Link Connector (DLC).
5. The scanner will automatically link to the vehicle and will display
a main menu.
Note: Do not connect or disconnect the scanner while the ignition
is on or the engine is running.
Diagnosis
Important:
to the vehicle's service manual for detailed instructions.
Select "OBD II / EOBD" in main menu and press "OK". The scanner
will automatically check the vehicle's computer and display a
diagnostic menu.
5
3. Connect the scanner's 16-pin
Connector to the vehicle's DLC.
1. Read Codes
has malfunctioned.
2. Erase Codes
This option erases codes in the vehicle after retrieving codes from
the vehicle and certain repairs have been carried out.
3. I/M Readiness
This option checks whether or not the various emission-related
systems on the vehicle are operating properly, and are ready for
that a repair has been performed correctly, and/or to check for
Monitor Run Status after the repair has been performed.
Explanation of terms:
• MIL - Malfunction Indicator Light
• IGN - The Ignition Method of the Vehicle
• DTC - Diagnostic Trouble Code
• PdDTC -Pending Diagnostic Trouble Code
• FUE - Fuel System Monitor
• CCM - Comprehensive Components Monitor
• CAT - Catalyst Monitor
• HCAT - Heated Catalyst Monitor
• EVAP - Evaporative System Monitor
• AIR -Secondary Air Monitor
• O2S - O2 Sensor Monitor
• HRT- O2 Sensor Heater Monitor
• EGR - Exhaust Gas Recirculation System Monitor
4. Data Stream
This option retrieves and displays live data and parameters from
the vehicle's ECU.
6
Publicité
