Publicité
en-us_main.book.book Page 17 Friday, June 14, 2024 3:40 PM
• Once the appliance is installed, extend the front and rear leveling legs below the rollers to improve the
stability of the appliance. Do not move the appliance with the legs extended. Front and rear leveling legs
can be adjusted from the front once the unit is positioned.
• If the unit has been on its back or side, it must stand upright for a minimum of 24 hours before turning
on the power.
• After the appliance is rolled into position, verify that the anti-tip brackets are properly engaged.
1
Remove the base panel.
2
Retract all front and rear leveling legs so the appliance can be wheeled forward and backward.
3
Plug the power cord into the outlet.
4
To use the icemakers or water dispenser, the refrigerator must be connected to the house water
supply. If needed, follow the instructions under Connecting Refrigerator to Water Supply to connect to
the house water supply before continuing to step 5.
5
Tie a long string around the middle of the power cord. Feed the string over the top of the appliance,
pull it until the power cord is held high off the ground, then tape the string to the front of the
appliance to hold the power cord off the ground. Do not pinch or strain the power cord. Make sure it
is still plugged in.
6
Carefully move the appliance into the enclosure, making sure not to pinch the power cord or water
line under or behind the appliance. If the water lines were connected at the front of the appliance,
tuck the water lines underneath the front of the appliance.
7
Remove the string from the power cord and the edge protection from the enclosure.
INSTALLATION
17
Publicité
