Publicité
CATEGORY SAFETY WARNINGS
Allow the tank to completely fill before using the
product.
Never transport the compressor with the tank
pressurized.
Always check that the compressor outlet pressu-
re does not exceed the maximum recommended
pressure of any attached tool or accessory.
Never weld or machine the tank. In the case of fa-
ults or corrosion, replace it.
This compressor must not be used for air supply
for human consumption.
PROTECTIVE EQUIPMENT
Make sure that you use appropriate and certified
personal protective equipment when operating
the product. Always wear eye protection goggles.
Clothing which does not hamper movements,
protective gloves, dust mask, ear protection and
safety boots with non–slip soles will help prevent
or reduce injuries. Never wear scarves, necklaces
or any hanging accessory and clothing that could
be caught in the product during its operation. Tie
up your hair if it is long.
MOVING PARTS HAZARDS
Moving parts can cause serious injury. Avoid con-
tacting such parts when they are still in motion
and make sure that you keep anything that could
be trapped in the operating product, such as ex-
tremities, loose hair and clothing, away. Do not
touch the moving parts before they come in com-
plete stop. Use only the specified handles on the
product.
Check for correct alignment of moving parts or
other failures that could be a source of danger. A
damaged guard or other part should be replaced
by an authorized service center before operating
the product.
ELECTRICITY HAZARDS
Make sure that the electric cables of the product
and the mains plug, that it is connected to, are in
good condition and not worn. Never use a dama-
ged product or a product with damaged or worn
electric cables and plugs. Make sure that the elec-
tric cable does not come into contact with the hot
parts of the product and also protect it from heat,
oil and sharp objects. Do not expose the product
and the electric cables to wet conditions and ne-
ver touch when wet. Do not use the cable to pull
the plug out of the socket.
Use a socket outlet with ground contact. Do not
come in contact with grounded surfaces or elec-
tric cables, to avoid the risk of electric shock.
The voltage and frequency ratings of the electri-
city supply must be within the specifications of
the product.
When the product is to be used outdoors, use
only extension cables intended for outdoor use.
The cross section of any extension cable must be
of the appropriate size and the mains connection
must be protected by an appropriate fuse. Con-
sult a qualified electrician for further instructions.
FIRE AND BURN HAZARDS
Some parts of the product get hot enough during
operation to cause burns and ignite flammable
materials.
Do not touch hot parts in order to avoid getting
burned. Let the product cool before storing it.
Do not use the product in areas with high risk of
fire. If a fire occurs, use an appropriate fire extin-
guisher.
PRODUCT SPECIFICATIONS
INTENDED USE
This product is designed and manufactured for
short term storage of high pressure air.
Any other use differing from the one mentioned
above could be hazardous, harm people and/or
damage things and the product itself.
IMPROPER USE
This air compressor is designed to compress nor-
mal air. Never use it to compress any other type
of gases. The product must not be used for hazar-
dous materials, e.g. accumulation of inflammable
or explosive materials and any other object that
could be dangerous to the product itself as well
as the operator, bystanders, animals or property.
Other examples of improper use may include, but
are not limited to, operation of the product:
Without the original accessories supplied by the
f
manufacturer.
With original accessories but in a way not in accor-
f
dance to the instructions.
Without original spare parts.
f
With unauthorized modifications.
f
NOTE
According to the applicable product liability laws,
the manufacturer of the product does not assume
liability for damages to the product or damages
caused by the product that occurs due to:
Improper handling not complying with the opera-
f
ting instructions.
Repairs by third parties and not by authorized ser-
f
vice technicians.
Installation of non-original spare parts.
f
Non-intended use.
f
Powering the product not accordingly to its spe-
f
cifications.
TECHNICAL DATA
Refer to respective table, at the end of this ma-
nual.
IDENTIFICATION (FIG. 1)
1. Compressor
2. Motor
3. Oil sight glass
4. Tank
5. Rear transport wheel
6. Drain valve
7. Front transport wheel
8. Power cable
9. Water trap with filter
10. Pressure gauges
11. Outlet regulator
English | 11
www.ffgroup-tools.com
Publicité
