Publicité
Model - Modello - Modèle
Modell - Modelo - Modelo
Constructeur - Fabbricante
Manufacturer - Hersteller
Fabricante - Fabricante
21.
PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories,
it must be left to stand for at least three hours before being started to allow the
lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of
the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE
REFRIGERATOR WILL HAVE TO BE CONNECTED IS
TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL
SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED
TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple
socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught
or stepped on, away from water and the other liquids and heat sources and must not
be damaged. In case of breakage of the power cable of the cabinet, it must be replaced
by the manufacturer or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying
with the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things
due to incorrect observance of this rule.
22.
INSTRUCTIONS FOR CORRECT INSTALLATION AND
MAINTENANCE
The user and maintenance instructions are found in the User Manual available on the website www.
eptarefrigeration.com.
The installation instructions dedicated to expert personnel are available:
•
From the service network
•
In some product categories in paper form delivered with the product.
23.
PROFESSIONAL REPAIR SERVICES
The services are provided by our service network that can be consulted in the contact area at the
web address: www.eptarefrigeration.com.
24.
SPARE PARTS
The spare parts and the information to repair the unit are available for at least 8 years after the
product is declared out of production at the following web address: www.epta-service.com/
service/.
The credentials are provided on request by sending an email to: servicesupport@eptarefrigera-
tion.com
GLEE 45 LITE/PRIME V3
GLEE 55 LITE V3
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
2 4 / 8 4
PAGE
UM000723
N° DOC
Publicité
