Publicité
Risk of severe injury or death by electrical shock.
•
To reduce risk of electrical shock, disconnect power before working on or around the system. More than one disconnect switch
may be required to de-energize the equipment before servicing.
•
Wire pump system for correct voltage.
•
Do not use an extension cord; provide a properly located outlet.
•
Check electrical outlets with a circuit analyzer to ensure power, neutral, and ground wires are properly connected. If not, a quali-
fied, licensed electrician should correct the problem.
•
The pump shall be properly grounded. If the product is supplied with a grounding conductor and grounding-type attachment
plug. To reduce risk of electric shock, be certain that it is connected only to a properly grounded grounding-type receptacle. Do
not remove the third prong from the plug. The third prong is to ground the pump to help prevent possible electric shock hazard.
•
To avoid hazards when installing or servicing, install a double-pole disconnect near the pump installation.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
•
Do not bury cord. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other equipment.
•
Check local electrical and building codes before installation. The installation must be in accordance with their regulations as well
as the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
•
Do not use the power cord for lifting the pump.
Risk of bodily injury, electric shock, or equipment damage.
•
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experi-
ence and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with the unit or in
the immediate vicinity.
•
Equipment can start automatically. Always unplug the pump power cord and disconnect the electrical power before servicing the
pump or switch.
•
Make sure that the discharge line of the pump is secure before operating pump. If the discharge line is not secured it could move.
•
Do not run pump dry. Running dry will cause serious damage to the pump.
•
Do not let the unit freeze. Freezing may cause cracking or distortion that may destroy the unit.
•
An inoperative or malfunctioning pump could lead to flooding, resulting in personal injury or property damage.
•
Operation of this equipment requires detailed installation and operation instructions provided in this manual for use with this
product. Read entire manual before starting installation and operation. End User should receive and retain manual for future use.
•
Keep safety labels clean and in good condition.
•
This pump has been evaluated for use with water only. The pump should only be used with liquids compatible with pump com-
ponent materials. If the pump is used with liquids incompatible with the pump components, the liquid can cause failure to the
electrical insulation system resulting in electrical shock.
•
In applications where property damage and/or personal injury might result from an inoperative or leaking pump due to power
outages, discharge line blockage, or any other reason, an automatic back-up system and/or an alarm should be installed.
•
A liquid-tight stand-pipe arrangement shall be provided in the end-product application to keep the power supply cord from
being exposed to the fluid being pumped if other than water.
•
Power cord supplied with this pump should not be in contact with the solvent. The solvent may attack the cord insulation, caus-
ing cord to become stiff or lower the insulating properties.
•
The pump motor is equipped with an automatic resetting thermal protector and may restart unexpectedly. Thermal Protector
tripping indicates motor overloading or overheating.
SAFETY INSTRUCTIONS
Specifications
5
Publicité
