Publicité
Trouble
Nailer does not operate.
No actuation occurs.
Fastener jammed.
Underdriven fasteners.
Overdriven fasteners.
Troubleshooting
Cause
No battery inserted, battery
discharged.
Battery and tool tempera-
ture too low.
Nailer not switched on.
Sequential operation has
not been conducted cor-
rectly.
Workpiece contact is not
fully depressed.
Dry fire lock out activated,
minimum amount of fasten-
ers left in the magazine.
Fastener jammed.
Fasteners used are not ap-
proved.
Magazine is empty.
Debris, dirt, or jammed
fastener in nosepiece and/
or magazine.
Depth of drive is not set
deep enough.
Fastener is too long.
The battery is discharged or
defective.
Depth of drive is set too
deep.
Fastener is too short.
Action
Insert charged battery.
Allow battery and tool to warm
up sufficiently to operating am-
bient temperature. See "Specifi-
cations" on page 11.
Press On/Off Button 7 for 1.5
seconds. (See Fig. 1.)
See "Nailer Actuation" on page
20.
See "Nailer Actuation" on page
20.
Refill the magazine. See "Load-
ing the Magazine" on page
15.
See "Jam Clearing" on page
23.
Only use approved fasteners.
See "Fastener Selection" on
page 12.
Refill the magazine. See "Load-
ing the Magazine" on page
15.
See "Jam Clearing" on page
23.
Adjust depth setting wheel
to increase drive depth. See
"Depth of Drive Adjustment" on
page 19.
Only use approved fasteners.
See "Specifications" on page
11, "Fastener Selection" on
page 12.
Insert charged battery. See
"To Insert the Battery Pack" on
page 13.
Adjust depth setting wheel
to decrease drive depth. See
"Depth of Drive Adjustment" on
page 19.
Only use approved fasteners.
See "Specifications" on page
11."Fastener Selection" on
page 12.
25
Publicité
