Publicité
Jam Clearing
(Fig. 19)
Follow the jam clearing procedure when a
fastener is jammed:
1. Switch the nailer off by pressing the
On/Off Button 7.
2. Remove the Battery Pack 9 from the
nailer.
3. Remove all fasteners from the Magazine
14. See section "Loading and Unloading
the Magazine" on page 15.
4. Open the Jam Clear Latch 3 by lifting it
upward then rotate it open.
5. Remove the jammed fastener, using
pliers if needed. If necessary, clean any
trapped dirt or debris.
6. Close the Jam Clear Latch 3 by rotating
it closed, ensure that the latch pin is
engaged, then press the latch down.
7. Refill the Magazine 14. See section
"Loading and Unloading the Magazine"
section on page 15.
8. After successfully clearing the jam, fol-
low the section "Daily Inspection and
Testing" on page 15 to ensure normal
operation of the nailer.
NOTE: If the driver blade does not return to
its up position, remove the Battery Pack 9
and contact a Bosch service center or autho-
rized Bosch service station.
Troubleshooting
Fig. 19
Fig. 20
3
3
23
Publicité
