Publicité
5. Firmly grip the Handle 19 and pull the
Trigger 6
to activate the nailer.
6. Depress the Workpiece Contact 2 fully
against the work surface
fastener ; do not release the Trigger
6. The Workpiece Contact 2 must be
fully depressed within 5 seconds after
the Trigger 6 is pressed. If the Work-
piece Contact 2 is depressed later, the
nailer will revert to a SAFE mode and
the actuation sequence will have to be
repeated. If the Workpiece Contact 2 is
not fully depressed into the nailer, the
nailer will not fire.
7. The nailer will recoil after the fastener
is driven into the work surface. Use
sufficient grip to maintain control and
alignment of the nailer with the work
surface during firing and recoil.
8. Continue to hold in the Trigger 6 and
pull the nailer away from the work
surface.
9. To fire another fastener, press the Work-
piece Contact 2 at the next firing loca-
tion; this step may be repeated as long
as the Trigger 6 is continuously held in.
Once the trigger is released, steps 5-8
must be repeated.
Fig. 18
7
6
Operation
to drive the
19
2
21
Publicité
